setup new comp and nothing. :(

royalmarine · 12-16-2007, 09:01 PM

was hoping not to have to spend anymore money on it.

im just after buying the board last week off someone. and it cost me 160 euro!

as for soldering a new pin on, would that work? the pin from the board is there, its just been bent over and snapped.

ill have a crack at it tomorrow and see what i can do. only problem is its so small and hard to get to.

royalmarine · 12-18-2007, 11:50 PM

right. the pin is too hard to get to.

so im gonna use the 90 day step up and swap it to the 780i.

thanks for all the help on that lads. owe ya one.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-16-2007, 09:01 PM	#21 (permalink)
royalmarine Gold Member Join Date: Nov 2007 Posts: 374	was hoping not to have to spend anymore money on it. im just after buying the board last week off someone. and it cost me 160 euro! as for soldering a new pin on, would that work? the pin from the board is there, its just been bent over and snapped. ill have a crack at it tomorrow and see what i can do. only problem is its so small and hard to get to.

12-18-2007, 11:50 PM	#22 (permalink)
royalmarine Gold Member Join Date: Nov 2007 Posts: 374	right. the pin is too hard to get to. so im gonna use the 90 day step up and swap it to the 780i. thanks for all the help on that lads. owe ya one.