|
|
||
09-30-2005, 08:34 PM
|
#1 (permalink) |
|
New Member
 Join Date: Sep 2005
Posts: 10
|
I/O Shield
installed new motherboard in my case, the i/o shield was a pain but i finally got it to fit but i had to put a lot of pressure on the motherboard to line it up correctly with the standoffs to position correctly with the shield, but it fits now and even pushes out a little bit, is the pressure going to be bad for the motherboard?
|
|
|
|
10-06-2005, 01:19 PM
|
#3 (permalink) |
|
Silver Member
 
Join Date: Sep 2005
Location: Virginia
Age: 18
Posts: 116
|
I wouldnt worry about it as long as everything is working properly.
__________________
ati radion x600 pro duel screen 1512mbs of ram (ddr2) 2 ata 160 gig hds 680 watt power supply (got it for 27$!!!) NZXT Nemesis Gaming Case with 3 120 mm fans dell demension 8400 check out my forum at www.biohazardpc.com |
|
|
|
|
10-06-2005, 08:18 PM
|
#4 (permalink) |
|
Moderator
 
Join Date: Jan 2005
Location: Netherlands
Age: 21
Posts: 8,280
|
when you didnt put in any screw, how much the mainboard was away from the position it actually had to be?
__________________
Newton is dead, Einstein is dead, I don't feel very well either Xfire - Mirrari Intel Q6600 ( @3.6GHz) Asus Triton 79 Amazing 549/3200 4x 1Gb Corsair XMS2 DDR800 Asus Maximus Formula Asus & Sapphire HD3870 512Mb ( 850/1180 ) Corsair HX620W PSU |
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
