msi K7N2 Delta-L motherboard

joprout · 11-23-2004, 03:35 AM

Recently I changed the processor bus settings from 100 to 133 within the Bios. When I rebooted, the monitor did not come on, flashing Check Cables and PC on the screen. The PC acts like its starting up. I can hear the hard drive spin up, the cd rom blinks and makes noise, and the HDD activity light lights up. I set the JBAT1 jumper to the Clear Data position and still nothing. I removed the other 2 jumpers for a few seconds(J10 and J11) with the pc off, replaced them and tried again with no luck. I looked for help on line and found information about a JP3 jumper that resets this setting, but I can't find that one on my board. Any help would be great!

MSI K7N2 Delta-L - Award Bios - 400 FSB
AMD Atalon XP 2100+ - 266FSB
Maxtor 40 GB HDD
2 sticks 256MB DDR 2100 - set in Dual Channel
52x cd rom
4x cd burner
ATI Radion 7000 64MB AGP
300 Watt power suply
Windows 2000 SP3
Gateway 700 monitor
"D" bracket usb 2.0

**Praetor** · 11-23-2004, 04:22 AM

Quote:

I set the JBAT1 jumper to the Clear Data position and still nothing

Did you also remove the battery?

Quote:

I removed the other 2 jumpers for a few seconds(J10 and J11

And what do these jumpers do?

Quote:

The PC acts like its starting up. I can hear the hard drive spin up, the cd rom blinks and makes noise, and the HDD activity light lights up

Maybe the system thinks its been OCd too much? For starters, you'll definitely have to reset the CMOS (which is what youve been trying to do). Th

11-23-2004, 03:35 AM	#1 (permalink)
joprout New Member Join Date: Nov 2004 Posts: 2	msi K7N2 Delta-L motherboard Recently I changed the processor bus settings from 100 to 133 within the Bios. When I rebooted, the monitor did not come on, flashing Check Cables and PC on the screen. The PC acts like its starting up. I can hear the hard drive spin up, the cd rom blinks and makes noise, and the HDD activity light lights up. I set the JBAT1 jumper to the Clear Data position and still nothing. I removed the other 2 jumpers for a few seconds(J10 and J11) with the pc off, replaced them and tried again with no luck. I looked for help on line and found information about a JP3 jumper that resets this setting, but I can't find that one on my board. Any help would be great! MSI K7N2 Delta-L - Award Bios - 400 FSB AMD Atalon XP 2100+ - 266FSB Maxtor 40 GB HDD 2 sticks 256MB DDR 2100 - set in Dual Channel 52x cd rom 4x cd burner ATI Radion 7000 64MB AGP 300 Watt power suply Windows 2000 SP3 Gateway 700 monitor "D" bracket usb 2.0 __________________ Thank you. Jmbanane

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode