Update!
I spent a good 4-5 hours designing and then cutting these panels out..
They are the Top, Front (still needs etches), Bottom and rear panels. The notches in the front and rear panels are for the motherboard panel, and I havn't made a hole at the back for the I/O ports yet because I don't have an mATX I/O shield to hand at the mo!
They all fit together using a series of male a female teeth as it were... Here are some of them flat together...
A close up of how the teeth fit together.. They are 10mm long and 5mm deep (i'm using 5mm acrylic for these)
The rear panel. I still need to mill the hole for a DVD drive, but I'm still deciding between brands and sizes. The rear PSU port should take basically any PSU (fingers crossed! :dremel
And how it basically looks now..
I did do some more work, but unfortunately I also ran out of battery in my camera :sigh:
More progress tommorrow! :thumb:
AJ¬