|
|
#1 (permalink) |
|
New Member
![]() Join Date: Aug 2007
Posts: 1
|
I want to buy a new motherboard but there is a problem. Almost all i'm interesting in have only 1 IDE connector. The problem is that i have an ide hard disk 250gb and an atapi dvd rw. If i connect the hard disk and the dvd rw to the same ide connector (as master and slave if i'm not wrong) will the hard disk perform in slower speed (at my asrock p4vm800 mobo when i do this the hard disk operates in lower dma mode)
I would really appreciate any answer. Thanks in advance. |
|
|
|
|
|
#2 (permalink) |
|
Moderator
![]() Join Date: Dec 2004
Location: Canada
Age: 24
Posts: 10,085
|
Yes and no. The ATA controller can run them at different speeds so your hard drive isn't limited to ATA33 or anything like that. But only the CD drive or hard drive can talk on the cable at a given time so if both are in use at the same time they have to wait for each other to finish.
__________________
You know what the chain of command is? It's the chain I go get and beat you with 'til ya understand who's in ruttin' command here. I must plug a couple comics because they are good :D: www.ctrlaltdel-online.com www.userfriendly.org |
|
|
|
|
|
#3 (permalink) |
|
Diamond Member
![]() Join Date: Aug 2006
Location: Australia
Age: 16
Posts: 1,386
|
You can get PCI Cards that give out IDE Ports.
I would do that.
__________________
GigaByte K8N Nforce Pro-SLI AMD 3800+ Socket 939 2048MB PC3200 DDR Matched RAM 960GB Hard Drive [3 x 320GB SataII Seagate's] Albatron 8600GT 256MB *New. . .Too me* 21" ViewSonic LCD Monitor 6.3 Sound System |Desktop| |Setup!| |Inside Computer| |Server| Updated Setup! Check out My Banner! When The Rich Wage War Its The Poor Who Die. |
|
|
|