No Source, DVI, or VGA Signal??

Discussion in 'Video Cards and Monitors' started by tylau2, Feb 15, 2011.

  1. tylau2

    tylau2 New Member

    Messages:
    3
    I have an HP Pavillion

    My monitor starts up but the message "No Source Signal, DVI- NO SIGNAL, VGA- No Signal" just bounces around the screen. Any ideas? Thanks!
     
  2. Demilich

    Demilich New Member

    Messages:
    300
    The monitor is connected, correct? What brand of monitor?
    Does the computer start up as normal; no beeps, clicks, etc.?
    Have you jiggled the cord?
     
  3. tylau2

    tylau2 New Member

    Messages:
    3
    monitor is an HP 2009 m

    everything is plugged in and no beeps or clicks!
     
  4. Nanobyte

    Nanobyte New Member

    Messages:
    1,172
    The most obvious test would be to attach to another PC to see where the problem lies. Does the HP have a graphics card and/or onboard graphics?
     
  5. tylau2

    tylau2 New Member

    Messages:
    3
    I will try plugging the monitor into a different tower and see if that works. Im not sure about the graphics card. How would I go about find that information out?
     

Share This Page