spacedude89
Active Member
could i take a small freezer and cut two holes in it, put a hose from the hole to the intake fans on my computer?? would humidity be a problem?
*shudder*The way fridges and freezers work is they pull the hot air out of it leaving just the coldness, or something like that.
Or he wants a cool (as in temperature) computer. Just look at vapochills.why is it that you wanna do this? hahaha, seems like you have a little to much time man . lol
Basically monitoring the temperatures at a few places and doing some calculations with a psych chart. Then assume reasonable ambient temps and humidity ratios/relative humidities. Do some mixing calcuations somewhere in there.im intrigued as to what your methods are
That’s what I was assuming you would do. I was just giving a safe way to do it; probably overkill though.haha, i was thinking of just putting a small freezer next to my computer, and cutting two holes, one in each side, then taking rubber hoseing and connecting it to one hole, then fasten it in front of one of the fans(mabey both),
I would actually be concerned of the opposite – that the fans would not be able to pump well enough. You’ll be adding a bit of fluid resistance to the air flow (friction factor = 64/Re for laminar flow) both on the intake and exhaust (I’m assuming you’ll be exhausting back into the freezer)i dont know if it would cool the air fast enough though,
As I said before, the cold air isn’t what you need to worry about. It’s the warm air that can have a significant humidity ratio (more relevant here that relative humidity). As this air is cooled to its saturation temperature water will condense.im not worried about condensation too much,(cold air holds less water, warm air holds more) as the air heats up, the humidity should go down since it can now hold more water, if you know what i mean.
How warm is warm?2. ive been overclocking everything (ram,cpu,video card) and it gets pretty warm,
Damn that’s a warm room. I like to have mine at ~65F if possible.3. i like my room about 80, so the air going in to the computer is pretty warm to start with,
Maybe if you can think of a way to perfectly seal it so absolutely no outside air gets in.haha, i just got an idea, i could seal up my computer really good, and have the inside refridgerated, insted of just blowing cold air in, i could put the cooling unit from the fridge into the computer, hmmm case temps of 0 celesus.........
That really depends on the heat load of the computer and the ability of the freezer. One reason for exhausting to the freezer is that the air would already be dehumidified (at least somewhat compared to ambient), so there wouldn't be too much worry about the air being dehumidified inside the freezer.I would recommend exhust to the room, and take fresh air in to the freezer to cool as it probably wont cool the warm air from the case fast enough and the room would be a few degrees cooler,
Desicants (those anti condensation crystals) might help, worth a try at least but their performance can be quite limited and a pain in the ass since you have to constantly replace them.also try putting a filter of those anti condensation crystals in between the freezer and the comp
Who said anything about transporting it?Use a mini fridge,easier to carry
What? Could you try to explain your comments?Mini FREEZER or FRIDGE as can alter temperature
Those are only single-phase change units right?If you really want to do something with your freezer (and don’t mind tearing it apart), use the compressor to build a direct die vapor compression CPU cooler.