DDR200 128Mb kit?

Archangel

Archangel

VIP Member
DDR200 128bit kit?

well... i just noticed that my pc says on booting.
DDR 200 Dual channel 128bit

however, its DDR400 (pc3200). so whats up with that?

(pc = sig )
 
Last edited:
CPU-z says that the
FSB-ram is 150MHz.
cas# latency is 2.5

and when i go to the other tab (SPD) it says in the SPD timing table.
frequenty - 200 MHz


and there also stands (just over the table) Max Bandwith = 200MHz (pc3200)


does this mean, my RAM is clocked at 150 while it could run at 200?

ow, and the bios is a bit funky.. so i havnt found it yet :P
 
well, its weird that you bios set up a ratio if one wast needed, If you ram will run in sync this you cpu and 200 fsb then you should run it at 1:1 for best performance
 
so now its not 1:1? i mean.. the prosessor should be 200, right? and the RAM is 150 :S
well,.. do i need to change something,.. and if i would, would i notice a difference?
 
Well in my head the number don't work, to common ratios, but anyway...

You didn't do what i said in post #5.
Goto cpu-z, open page "memory", look for the line that says fsb:dram ratio

post that ratio here

;)
 
You must log in or register to reply here.
Back
Top