Bankai
New Member
Hello I recently purchased the following products for my new computer over a week ago.
Motherboard: NVIDIA EVGA nForce 790i Ultra SLI ATX Intel Motherboard
Processor: Intel Quad-Core QX9650
Memory: Corsair 4GB DDR3 SDRAM 1333 (PC3 10666)
HDD: 150GB Raptor | 2 x Seagate 750GB Drives
Graphic Card: EVGA 512-P3-N841-AR GeForce 8800GTS (G92)
CD/DVD: MAIN DVD Multi Recorder 20x LightScribe
OS: Vista Ultimate 64 Bit
When putting together the system everything was fine until I encounter the following error when I stuck in all four sets of RAM into all the banks "C1 Base Memory Detect". I tried everything I could think of fixing this problem from updating the motherboard to the latest Bios and clearing the CMOS but still no luck. The system works only if I have two sticks of RAM in the last two banks (2 and 3). When I try to install RAM into Banks 0 or 1 the computer will make a long beep sound and will list the C1 error code on the motherboard.
I know that the memory works because I switch them back and fourth and only work in the last two banks. I'm thinking if the memory controller for the first two banks is either defective or there's something I'm doing wrong. If you guys have similar problems with this board or have an answer to fix this problem please let me know.
Thank you.
Motherboard: NVIDIA EVGA nForce 790i Ultra SLI ATX Intel Motherboard
Processor: Intel Quad-Core QX9650
Memory: Corsair 4GB DDR3 SDRAM 1333 (PC3 10666)
HDD: 150GB Raptor | 2 x Seagate 750GB Drives
Graphic Card: EVGA 512-P3-N841-AR GeForce 8800GTS (G92)
CD/DVD: MAIN DVD Multi Recorder 20x LightScribe
OS: Vista Ultimate 64 Bit
When putting together the system everything was fine until I encounter the following error when I stuck in all four sets of RAM into all the banks "C1 Base Memory Detect". I tried everything I could think of fixing this problem from updating the motherboard to the latest Bios and clearing the CMOS but still no luck. The system works only if I have two sticks of RAM in the last two banks (2 and 3). When I try to install RAM into Banks 0 or 1 the computer will make a long beep sound and will list the C1 error code on the motherboard.
I know that the memory works because I switch them back and fourth and only work in the last two banks. I'm thinking if the memory controller for the first two banks is either defective or there's something I'm doing wrong. If you guys have similar problems with this board or have an answer to fix this problem please let me know.
Thank you.
Last edited:
