In compatable hard drive?

M

mikemmx

New Member
I just build a new PC. I took my old hardrive from the old PC and put it in. when i try to install windows XP i get a blue screen error saying

I need to remove hardrive contoller, run CHKDSK /F, check for virus, and stuff...
"Stop : 0x0000007b (0xf7a2a636, 0xc0000034, 0x00000000)"

I dont have a hard drive contoler. I ran chkdsk.
I tryed it with 3 hardrives, 1 from another PC. they all cant be broken.

motherboard
http://www.newegg.com/Product/Product.asp?Item=N82E16813131545&ATT=Motherboards+Intel&CMP=OTC-P12ice5can
 
sound cd related (since you have tried other hdd's), is the cd genuine or a copy. Do you have another xp cd you could try using
 
well dont realy wanna give bill my money, his windows is full of hose, and its way over priced.
the second disc dint work..either

"did u try format first?"
the drive is empty. i reformated it.
yet sill no luck.
 
Last edited:
Do I really need to remind you that this forum has rules?

mikemmx said:
the CD?
well nope its not genuine
and yes i got another one, ill keep posted
Click to expand...

mikemmx said:
well dont realy wanna give bill my money, his windows is full of hose, and its way over priced.
Click to expand...

I guess so... Read the first rule.
 
ohh, sorry u can delete it if you want.

well i found this on micosoft site.
- but i never got pass step 1, then I see the error.

A "Stop 0x0000007B" error message occurs when you start your computer after you install a new motherboard
When you start your computer after you install a new motherboard, you may receive the following error message on a blue screen:
STOP: 0x0000007B: (parameter1, parameter2, parameter3, parameter4)
INACCESSIBLE_BOOT_DEVICE
Cause
This problem may occur if the new motherboard contains an embedded IDE controller that uses a different chipset than the original motherboard.
Resolution
To resolve this problem, restart Windows 2000 Setup and then repair the Windows 2000 installation. To do so, follow these steps: 1. Start your computer by using the Windows 2000 Setup floppy disks or from the Windows 2000 CD-ROM.

Note To start your computer from the Windows 2000 CD-ROM, your computer must be configured to start from the CD-ROM drive or DVD drive. For more information about how to configure the computer to start from the CD-ROM drive or DVD drive, see the documentation that came with your personal computer or contact the manufacturer.
2. At the Welcome to Setup screen, press ENTER.
3. Read the license agreement, and then when you are prompted to accept the Windows 2000 licensing agreement, press F8.
4. Select your current installation of Windows 2000 (if it is not already selected), and then press R.
5. Follow the instructions that appear on the screen to repair your installation of Windows 2000.
Click to expand...
 
... I suppose, since that might be the problem.
im try get it off ebay cheap then... *sigh*.. i never knew building a comp is to complicated.
 
What is your type of mothoerboard? Are the NEW driver SATA? And the old drives IDE? Most of the newer mobo's dont carry the IDE drivers if they are primarily a SATA user..
 
You must log in or register to reply here.
Back
Top