OvenMaster
VIP Member
About two weeks ago, I had trouble booting my system (as shown below).
When I pushed my rig's power button, the fans spun up, but my hard drive light glowed steadily and I got a black screen. I would need to push the reset switch for a warm boot, and everything would boot up normally.
As I was replacing my known-to-be-dying PSU, I noticed two leaking caps and two bulging caps on my PNY-Nvidia FX 5200 256MB AGP 8x card. I replaced the faulty caps with new aluminum-polyester types.
I was only able to boot up in Safe Mode. Installing the 175.19 Forceware drivers (the last ones released for this card) would fail halfway through... my monitor would go black and only display an "OUT OF RANGE" message.
I took the card out and installed it in an old Emachines. Booting and installing the Forceware drivers went without a single problem, proving my videocard repair job was satisfactory.
I tried installing the card again in my system shown below. All I can get is Safe Mode, so I'm stuck with crappy S3/VIA onboard video.
It looks to me like I can no longer use my AGP slot. Everything else on my pc works fine, but is it possible that one of the leaking/damaged capacitors took out a part or two on my motherboard?
When I pushed my rig's power button, the fans spun up, but my hard drive light glowed steadily and I got a black screen. I would need to push the reset switch for a warm boot, and everything would boot up normally.
As I was replacing my known-to-be-dying PSU, I noticed two leaking caps and two bulging caps on my PNY-Nvidia FX 5200 256MB AGP 8x card. I replaced the faulty caps with new aluminum-polyester types.
I was only able to boot up in Safe Mode. Installing the 175.19 Forceware drivers (the last ones released for this card) would fail halfway through... my monitor would go black and only display an "OUT OF RANGE" message.
I took the card out and installed it in an old Emachines. Booting and installing the Forceware drivers went without a single problem, proving my videocard repair job was satisfactory.
I tried installing the card again in my system shown below. All I can get is Safe Mode, so I'm stuck with crappy S3/VIA onboard video.
It looks to me like I can no longer use my AGP slot. Everything else on my pc works fine, but is it possible that one of the leaking/damaged capacitors took out a part or two on my motherboard?