MS6367 MOtherboard

[mcavinee]

I tryed tatooing the board and upon boot up everything went silent. Now I get one beep code and some has said it is the memory stick. I take it out and the beep quits insert it and it beeps again. I think I need to clear the CMOS but do not see the jumper to do it. Some said take the battery out for two hours, I did and no change. Suggestions please. THank you

 

[apj101]

Some said take the battery out for two hours, I did and no change.

you need to unplug it at the same time as taking the battery out

I tryed tatooing the board

??? If your are trying to tatoo your bios, but dont even now how to reset it then are you sure your not in over your head??

 

[Praetor]

Some said take the battery out for two hours, I did and no change.

you need to unplug it at the same time as taking the battery out

And sometimes even set a jumper ... see the manual for specifics on howto. You'll never have to remove the battery for HOURS ... usually 10seconds is sufficient