Crazydude185
New Member
Alright im not sure if this is the right thread or not so move it if it isnt... but ok heres the problem... I have been building my new computer... everything was fine about 3 weeks ago... but then the power supply blew... I got it started before it blew and all the way to the desktop. But after I switched power supplies I get it to the boot up screen and It says Detecting IDE drivers then the screen
Primary Master : WDC WD1200BB- 00FTAO 15.05r15
Primary Slave : None
Secondary Master : _NEC DVD_RW ND-2500A 1.06
Floppy disk failed (40) but i dont have one hooked up so that is expected...
is there something wrong with this setup because it doesnt go to the desktop? it just stays here and doesnt continue to do anything... any advice would help... ?
Primary Master : WDC WD1200BB- 00FTAO 15.05r15
Primary Slave : None
Secondary Master : _NEC DVD_RW ND-2500A 1.06
Floppy disk failed (40) but i dont have one hooked up so that is expected...
is there something wrong with this setup because it doesnt go to the desktop? it just stays here and doesnt continue to do anything... any advice would help... ?
