Network Bridge...

M

MatthewC

New Member
Hi, I'm looking for some advice,

I am trying to connect 6 buildings together wirelessly using 6 of these:

- Cisco Wireless-G Access Point with Power Over Ethernet and RangeBooster (UK) WAP200-UK

So they are all on the same network, I understand I can use the bridge function on these access points, and then they become one network.

- But looking at the configuration on these devices, it will only allow me to put 4 MAC addresses in the Bridge set-up, is there anything I can do.. to set this up differently or any advice would be much appreciated.
 
Are you employed to know this stuff?

Have you set expectations that you cannot deliver?

The amount of questions required to answer this makes it painful to do you work for you.
 
No it's for personal use. I have 5 out buildings that I am intending to connect to the main home network.

I was just after a little advice that's all.
 
Sorry, i didn't mean to offend.

If you're limited to 4 MAC adresses then that is it. I would just have one access point with repeaters.
 
You must log in or register to reply here.
Back
Top