No display on new build

R

renzema

New Member
I have just finished building a new computer that will be just as a media center. The problem is I am receiving no display for the first boot.

I have tried with multiple monitors, and through the dvi, vga, and HDMI outputs with no display on any input. Personally never ran into this problem and I am not sure how to fix it.


The specs are as follows:

1 x GIGABYTE GA-F2A88XM-HD3 FM2+ / FM2 AMD A88X (Bolton D4) SATA 6Gb/s USB 3.0 HDMI Micro ATX AMD Motherboard

1 x AMD A4-6320 Richland Dual-Core 3.8GHz Socket FM2 65W Desktop Processor AMD Radeon HD8000 Series AD6320OKHLBOX

1 x Kingston 4GB 240-Pin DDR3 SDRAM DDR3 1600 Desktop Memory Model KVR16N11S8/4

1 x Seagate Barracuda ST1000DM003 1TB 7200 RPM 64MB Cache SATA 6.0Gb/s 3.5" Internal Hard Drive Bare Drive


Thanks for any help.
 
Also I have checked the standoffs, and they are all in the correct locations. Then reset the CMOS by removing the battery, just to be sure.

It powers on, and I can hear all the component running, just no display.
 
Last edited:
Do you know what bios revision is installed? That board won't support that processor unless the bios is version F6.
 
i think you might forgot to plug the power supply cord for your graphic card, open your case, try to find one or two 6-pin power cord comes out from the poser supply and plug it in on your graphic card. hope this helps : )
 
Albert it sound like he or her is using a A-series processor as both a GPU and CPU which there meant to be but this means if his or her computer CPU or GPU goes bad the module will need to be replaced but they'd cost similar to a good GPU any way. But lets ask some basic first. Does your motherboard have an LED to tell you it's powered if so check that is lit, if not most likely your PSU or Outlet is bad instead.

Ok so its running you say and you checked displays that sounds like either your motherboard or APU(CPU+GPU) is bad.
 
Last edited by a moderator:
You must log in or register to reply here.
Back
Top