old gateway can't see replaced hard drive

BARGAINBOB

New Member
I just loaded an older 40 gig HD with xp-pro, it is updated with sp3 and ready to go.
In fact I did it to two drives of the same size.
They work fine in my two older hp computers but when I install them, one at a time the gateway computer can't see either one.
The registry on the older gateway hard drive is way too big and the computer is real sluggish.

All the computers are P4 1.8 ghz, 2.0 ghz and gateway is a 3.06 ghz
I disconnected all other drives from the ide buss.
I get the cmos message. Cannot detect any hard drives.

The computer is about 6 years old with rd-ram.

Thanks for any help and ideas.
 
I just read your answer and then tried it. It gives the same message. I tried all jumper combinations with no good results. The CS and the no jumper act the same with the same cmos message.


Could there be a cmos virus???

Thanks
 
you do realize, if you install xp on a hp and move the drive to a gateway, even if the bios sees the drive, windows likely won't boot. you would probably need to do a repair install. If you going to do that, you may as well install it on the machine you intend to put the drive in. That being said, the bios should still "see" the drive. Try clearing the cmos.
 
Yes the PC should still see the drive and boot fully or partially. Sometimes I have got PC'S to boot fully in the past and all I have to do is check the hardware manager to see which hardware needs the proper factory drivers. Then I would go to the MBO or PC brand web site and download and install the proper drivers.
I have cloned drives in the past and done this with little problem.

The drive on this PC is running just fine and it will boot up a gateway pc I just bought in the bedroom.
Not the one I am having the problem with!
Although it is still the same vintage a 3.06 ghz single core p4.
I'm stumped!!
I guess I could try to reinstall XP from scratch of this problem pc.
 
Back
Top