Overclocking problems

iamsneaky13

iamsneaky13

New Member
I was over clocking my phenom 9650 and I think I may have broken it. I turn on my computer after saving thebios settings and there is no input on my monitor and the keyboard and mouse do not light up it is the system in my signature. I have a second of but it is intel and my brother is borrowing my new and pc
 
Take out the CMOS battery and wait about 30 seconds. Put it back in and start it. You'll have to boot into the BIOS and reset everything back to stable settings. This will clear all the saved BIOS settings you were running when it crashed.

When I used to overclock a lot I kept a notebook and would write down BIOS settings before I would take a run at it. That way when you have to clear it...you have a good idea where to start again. You will also have a record of what does not work;)
 
You must log in or register to reply here.
Back
Top