Photo PF1 running at 200mhz fsb

[deankenny]

I have put a P4 3.0ghz processor in this mobo and its still running at 200fsb how to i change it to 800 is it the jumpers ?????

 

[Archangel]

you'll have to put the fsb to 800 in the bios. ( or is the fsb of a p4 4 x 200? )

 

[34erd]

Just dont because then youl need to reset the CMOS lol

 

[deankenny]

yes i know ill have to reset thing is i go into bios and change it but then it gets to "save cmos and exit" but it just stops there cant get any further only thing that works is ctrl+alt+del

 

[34erd]

No I mean if you set the FSB to 800 your CPU will be running at 12 gigahertz and wont be able to turn on even. Theres no need to set your FSB higher unless your looking to overclock, even then setting it to 800 would just be stupid.

 

[deankenny]

it is only running at 200mhz because i do benchmarks and it says p4 3.0ghz (200mhz)

 

[34erd]

200 Mhz is the bus speed, not the CPU speed. Your CPU is running at 3 gigahertz.

 

[Filip]

200 Mhz is the bus speed, not the CPU speed. Your CPU is running at 3 gigahertz.

correct, and the FSB on pentium is quad pumped (200*4=800)

 

[Geoff]

correct, and the FSB on pentium is quad pumped (200*4=800)

hes right, the bus speed is 200mhz, same with my sempron, but your fsb is 800.