Please Help ASAP

SuicideMayne

SuicideMayne

New Member
I just got done bulding my comp

SPECS

Motherboard: LanParty UT nF4 SLI-D
Processor: AMD 64bit 4000+
Video Card: 2x BFG 6800GT's
Ram: 4x512 CORSAIR XMS PC 3200 Ram
PSU: Thermaltake Purepower 560watt

and when i plug my LCD in the video card the screen does not come on...i tried everything im really pissed because i spent like 1,800 on it and for some reason the screen wont come on everything powers on but the screen.....

i know there is no problem with the screen because im using it right now on my old comp....

please help thanxx
 
1. did you plug in both molex connectors to the mobo?
2. connect the monitor to the other videocard
3. did you set the SLI mode thingy?
 
Im assuming you've gone over the manual, i meant these
PCPC-Turbo-Cool-510-Express-molex.jpg
 
Use 1 DIMM (not all four, not three, not two -- ONE) and put it in the orange DIMM slot ... and flash zeee-bios :)
 
how do i flash zee bio's??

my comp screen dont even go on.......

i dont think its a problem with the cards..they go on and i tried it with both of them both of them cant be bad
 
Alright, if you can, try your graphics card in your problem PC on an older PC. If you can't, that sucks. I have had the same problem with a previous PC. It turns out that my CPU was fried. I hope this is not your problem. There are lots of things that can cause this.
 
a lot of times there is a small chip that needs to be flipped if using one or two video cards for the sli cards. Check the motherboard.
 
a lot of times there is a small chip that needs to be flipped if using one or two video cards for the sli cards. Check the motherboard.
Click to expand...
Points for reading posts: already dealt with in post2-3 ;)
 
You must log in or register to reply here.
Back
Top