power edge 2600 and raid recover

I

ishtiaq

New Member
Dear all.
hope you will be fine
i have a power edge server 2600 with raid 5 and was off,
after a long time when i switched on then i see there is raid off in bios.

i withdraw all hard disk from server and then i turn on the raid in bios.

now during startup i see there are logical drives but still getting en error nvram mismatch.

is there any way so that i can recover my raid and data.

regards.
ishtiaq
 
You may have turned raid on, but did you go into the bios and set up the array(s)?
 
You must log in or register to reply here.
Back
Top