Rivatuner OC problem

A

ada///M

New Member
Hey all, I've found a little bit of a problem and I'm hoping someone can provide me an easy solution:

basically I ran 3dmark the other day just to make sure things were going strong a week after my first build/OC and my score was down about 1300 points. When I look at the rivatuner display I saw that it was only 500. I figured out what the deal was with that, but that was not my problem. Basically the card goes to the clock I've set it to when the computer first starts up but after it does 3d graphics and goes back to 2d, it does not go back to the overclock speed when I want 3d again, if that makes sense. I let the graphs plot while I started a 3dmark run, then stopped it, then started another. See the attached picture:

gpumess.jpg


there has to be a way to keep the OC active throughout a session, any ideas?

specs are in sig


thanks!
-adam
 
this is officially driving my nuts! Just uninstalled/reinstalled the ati driver and rivatuner and it's doing the same thing! I don't think it could have been doing this before, what changed?!
 
try ATI TOOL .27b it works great at atarting up with windows to have fan set and OC set at start up
only thing i don't like about ati tool is the temps are 5oF higher than the real temps. but everything else is dead on.
 
hmm, I might have to check that out. I think I figured out my problem though, once I uninstalled ATi Catalyst it worked fine. Wierd though, since I'm pretty sure I had that from the start before...


thanks though!
 
Last edited:
You must log in or register to reply here.
Back
Top