Wire sleeving - how?

redrider773

redrider773

New Member
I'd like to sleeve my loose power supply wires, and some other fan wires and such. maybe green, so it looks like a water cooler :P . Any ideas on hows to?
 
Lol

Well you could use one of those wire tunnels or whatever they are called. You canspray-paint it, cut that from the back and then slide the wires in ;)

Here's what it looks like:

sleeve.jpg


JAN :D
 
i used some left over water cooling tubing, its green and UV reactive, cut a slit up one side, put your wires inside the tubing and then just close it, the tubng is fairly sturdy so it doesnt come open or anything, and it looks bloody cool.
 
The water cooling tubes are a good idea except for the whole turning corners thing. I use a lot of the plastic wrap. But the best way to avoid the whole issue is to remove the right side cover, trim holes in the mobo plate and add grommets to get around the sharp edges and run as many wires as possible behind the mobo tray and reattach the cover. What does not get covered is then the only area of concern.
 
Rick G said:
But the best way to avoid the whole issue is to remove the right side cover, trim holes in the mobo plate and add grommets to get around the sharp edges and run as many wires as possible behind the mobo tray and reattach the cover. What does not get covered is then the only area of concern.
Click to expand...

oo..that's a good idea, i might do that to mine.

And can't you just buy a wiresleeve redrider773?
 
You must log in or register to reply here.
Back
Top