Wireless coaxial???

redrider773

redrider773

New Member
Any way I can route, about 20 ft. wirelessly, cable tv? I've got a situation, can't run a cable, but need to get coaxial signal to TV Tuner card, any thoughts, ideas, or suggestions? Really could use help here.
 
as far as i know there is nothing taht exsets to do that. you just going to have to run a coax to the tuner card
 
damn. I've looked, and seen TV signal senders, but they only send the picture of what is on the other tv. it's complicated, but to run the cable, i'd need a 500' PATCH COAX! anyone know where I can get a 500' cable, with both male ends fastend; or how to fasten male ends on the bare wire :P no idea
 
go to lowes, home depot, you can buy rolls of these cables, for like 7 cents a foot, than just cut it where you need and put the connectors on each end. Its the least expensive way to go.
 
Just run them along the floor and hold it down with duct tape (or have your dad drill the holes and mount the connectors). As for the wireless-ness aspect of it, no, I don't believe it's possible (unless you try DTV or something).
 
redrider773 said:
check this out, a bit expensive thoughhttp://www.bestbuy.com/site/olspage.jsp?CategoryID=cat08059&id=1089891320402&skuId=6786873&type=product&ref=06&loc=01
Click to expand...
it work with line of site. the recever would have to be able to see the transmiter. it wouldn't work very well going through walls and floors. the more walls you have to go through the less the signal will be and the farther you are a way from it the the same thing will happen. get the coax and run it along the wall and duck tape or staple it in place.
 
You must log in or register to reply here.
Back
Top