Random shutdowns while gaming?!?

The GPU also has a heatsink, yes.

Lol have my card opened and DURRRRR , big heatsink that was a dumb question, everybody disregard that.

Lots of dust build up in heat sink but not too too much ,

Trying to take heatsink off card completely but these screws are stuck..
 
Just got heatsink off, dust covering half the thing in a thick layer lol

The thermal paste also looks ****ed, should I apply some more before putting back together (wiping the old off of course) or can I get away with putting it back together
 
Lol have my card opened and DURRRRR , big heatsink that was a dumb question, everybody disregard that.

Lots of dust build up in heat sink but not too too much ,

Trying to take heatsink off card completely but these screws are stuck..

Thats what I meant with look under the fan xD. Some coolers will be stocking much dust under their fan/fans.
 
Careful as you will probably need thermal pads too.

Couple of things, are you cranking the fan up during gaming. I had that card, they get hot.
 
Are thermal pads the metal part?? Can I just use thermal paste? I will most likely upgrade to gtx 680 when far cry 3 is released
 
Are thermal pads the metal part?? Can I just use thermal paste? I will most likely upgrade to gtx 680 when far cry 3 is released

So I'm going to the shop now do I deff need thermal pads?

Edit: can't find rubbing alcohol will acetone free nail polish remover work
 
Last edited:
Ended up cleaning without need for polish or ISO.

Just cleaned with qtip, trying to spread this thermal grease is a pain in the ass!! I can't seem to cover it without it coming off next time I try
 
So just ran OCCT again .... lasted 800 seconds until it hit 95Celsius and i turned it off...... Alot slower to reach that temp then before... But still reaching high temps .. I couldnt really get the thermal paste very even so just slapped the heatsink on..

I think the cards just done for.. ANy other advice would be nice... :(


Edit: Just reapplied thermal paste had to heat it up with hot water before i applied (Zelman grey grease is THICK) and ran OCCT for 20 Min at 77C with case opened.... Going to run some more tests and hopefully it is working fine again
 
Last edited:
Back
Top