GA-81pe1000 pro3 bios overclock FAILURE

[ronnie101]

Hey guys, I did a little reading on my mobo and decided to go into the bios to up some of the options.

I increased DIMM voltage, AGP voltage, and CPU voltage.

Now my computer refuses to boot up. It turns on then turns off immediately after, refusing to even turn on once more, unless I switch off and on the computer from the back.

Is there a way I can set my mobo to use default bios settings, so I can undo what i did wrong?

Thank you.

 

[Schonza]

All you need to do is reset the CMOS, that will reset the BIOS back to the default settings. Simply remove the battery on the motherboard, and leave it out for a good couple of minutes, then replace it. Then you're fine to boot up your pc.
Good luck.

 

[oscaryu1]

All you need to do is reset the CMOS, that will reset the BIOS back to the default settings. Simply remove the battery on the motherboard, and leave it out for a good couple of minutes, then replace it. Then you're fine to boot up your pc.
Good luck.

Change good couple minutes to seconds.

If it turns on and immediately turns off I would not think that the problem is more serious. If you overclock your computer too much it will run , but no image on the screen. If your computer immidiately shuts off look for possible overheating, shorting, or power supply issues.