650D molex/fan controller question

Mr.Moose

Mr.Moose

New Member
Hey people,

Currently assembling the computer in my sig and decided to take advantage of the built in fan controller on my Corsair Obsidian 650D. Now, I've plugged in the 3 pin fan controller connectors into each of the case fans, that's all good and well. So the last step would be to plug the 4-pin molex connector into one coming from my power supply? Well, I did that and what ended up happening was on the the pins kind of pushed through the back... See the attached picture:

http://imageshack.us/photo/my-images/832/img2091t.jpg/

Is this normal? Worst case scenario is I just ditch the built in fan controller and plug each of the case fans into the motherboard...

EDIT: Solved the problem myself, admin can close the thread
 
Last edited:
hey bud. you should be able to take a small screw driver and just push that pin back down. there is nothing broke here, its just the 4 pins didnt alighn up right and by the looks, 3 out of 4 did, so just puch and wiggle that one pin down and you will be good to go
 
You must log in or register to reply here.
Back
Top