Antec 300, MISSION!

Matthew1990

Matthew1990

New Member
I am on a mission to make Antec 300 cable managment friendly. This is impossible without cutting any holes, so I'll have to get my saw out. The thing is, where should I cut the holes.



How is this looking?

My PSU sits so the fan is up.
 
If my case had the holes in those marked places, it would be pretty much immaculate! Only bad thing I can think of is having the cables coming through the hole at the top - They're right in front of the fan. It might not make any difference to cooling though.
 
The locations look right but are you sure you have enough room to get the side panel back on? Also, your going to sharp edges that you are going have to fix.
 
I think I wold move the top slot over to the left since you can alway manipulate the wires. Good point by the guy above....
 
You must log in or register to reply here.
Back
Top