Athlon 64 x 2 5000+ Overcloking Specs

C

chriisy

New Member
So i was overclocking my CPU today n i was just wondering is the DRAM Frequency too high or is it just rite?

nqsock.png


2ql93dk.png


Thanks
 
It looks ok-I have mine running at 388.3 Mhz. But my memory timings are at 4-4-4-15 instead of 5-5-5-15. How high have you tried oc'ing the 5000+. I've had mine up to 3.3--crashed at 3.4 but haven't tried bumping voltage yet.
 
Looks good man, after 3ghz, your most likely going to have to bump up that voltage a little. I had mine at 3.05ghz w/o a voltage increase, i had a 5200+ though, same thing though. I personally would stop at 3ghz, just because the amount of power usage from 3ghz to 3.3ghz is such a large amout its not worth the little amount of extra performance.
 
That is as high as i can get it :(
Also how do you change the Core Voltage because i have been using CPUID and now its running at 1.3v but i wont it to go back to 1.1v but when i save changes and then restart it changes back to 1.3v.
I also don't think i have to option to change the Core Voltage in the bios.
Also when trying to change the Core Voltage using CPUID again i try and change it to 1.4v and then restart the PC and when i turn it back on its still 1.3v :(
Its also pretty crap that i cannot get past 3.00Ghz.

Thanks.
 
You should have a voltage option for the CPU in the bios. You might just not be looking in the correct section.
 
Its ok man, 3ghz is a good overclock, especially since you havent added voltage to the cpu. 400mhz overclock, pretty impressive.
 
You must log in or register to reply here.
Back
Top