Black Screen @ Boot Up

g4m3rof1337

g4m3rof1337

Active Member
I went to tighten my V8 screws since it was shutting my PC off, they were a bit loose, so I tightened them up quite a bit, then put my computer back together, and now when I go to boot up, I just get a black screen, I then decided to loosen them up a little, I'm still getting the same problem.



Any ideas?




Thanks.
 
Yeah, everything seems to be fine, my LED screen on my mobo is saying FF, which is what it usually says when it's fine.

I turn my computer on, then the monitor says No Signal Detected, and goes to idle. I switched my SLI cards to see if that would help, but nothing changed..


Could something have been permanently damaged when I tightened the CPU HSF?
 
You must log in or register to reply here.
Back
Top