BSOD fatal system error help needed ASAP!!!

[darth yoda]

ok i know i have posted about bsod before but didn't get any solutions that worked. i appreciate every1's help but would really like ppl to answer and nmot just post URL's. plz still post URL's but i would prefer answers.

ok i have gotten the following bsod:

1) 0x00000050 (0xA02C4963, 0x000000001, 0xBF810E85, 0x00000000)

2) PAGE FAULT IN NONPAGED AREA
0x00000050 (0xD40B94E0, 0x000000001, 0A804111A0, 0x00000000)

3) 0x0000008E (0xc0000005, 0xBF9266D, 0xBA010c30, 0x00000000)
win32k.sys - Address BF92696D base at BF800000, Date Stamp 48025F2a

thank you very much for you help.

 

[OvenMaster]

Possible Resolutions to STOP 0x0A, 0x01E, and 0x50 Errors
View products that this article applies to.
Article ID : 183169
Last Review : February 27, 2007
Revision : 2.2
This article was previously published under Q183169
SYMPTOMS
Windows NT computers, and those built on Windows NT technology, may stop responding (hang) with one or more of the following STOP error messages:
STOP: 0x0000000a
STOP: 0x0000001e
STOP: 0x00000050

Back to the top
CAUSE
These errors may be caused by one or more of the following:
• Hardware failure (memory, processor, or motherboard).
• Anti-virus software that is running on your computer.
• Drivers installed by third-party software.

Back to the top
RESOLUTION
To resolve these behaviors, perform one or more of the following:
• Replace the faulty hardware. You may be able to determine the faulty hardware by running diagnostics provided by the manufacturer. Please contact the hardware manufacturer for more information.
• Disable any anti-virus software that is running on your computer. If the STOP errors no longer occur, contact the anti-virus software manufacturer about a possible upgrade.
• Disable any third-party drivers that may be running. If the STOP errors no longer occur, contact the third-party manufacturer about a possible upgrade.

http://support.microsoft.com/?kbid=183169&sd=RMVP

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

0x0000008E: KERNEL_MODE_EXCEPTION_NOT_HANDLED

A kernel mode program generated an exception which the error handler didn’t catch. These are nearly always hardware compatibility issues (which sometimes means a driver issue or a need for a BIOS upgrade).

Microsoft Knowledge Base, and Google, are your friends.

Tom

 

[darth yoda]

thank you very much for your reply. just before i came to check who had replied i had another bsod. it was a

PAGE_INFAULT_IN_NONPAGED_AREA

0x00000050 (0x83c22014, 0x00000000, 0x804F47A3, 0x00000000)

i also tried a few things to try and stop the bsod's. i ran memtest on each of the sticks using their slots (not the same slot for each stick). i also swapped the hdd and used that one as a slave.

going by what u told me:

iv been using the same drivers for a long time so they are ruled out. same goes for the antivirus software (norton antivirus 2008).iv ruled out the memory (havnt I?) and also the HDD (havnt I?) it could be the CPU or the motherboard

motherboard - MSI KT4 Ultra
cpu - AMD Athlon XP 2600+ 1.92GHz

i looked on msi site at diagnostics they said about beeps excet the computer doesnt beep when getting a bsod. only sometimes if i restart instead of turning off but that doesnt give anything away either. what do u mean by diagnostics? how would i test the motherboard and cpu?

thanx