burner switch

g4m3rof1337

g4m3rof1337

Active Member
can i take my burner out of this computer, put a new one in, burn what i need, then take the new burner out, put in the new pc and use it

problems.
driver, can i use more than once on 2 different computers.
is it easy?
 
Yeah, you'll just have to make sure you power off the computer first.

When you put it in the new computer besure to check the jumper settings on the back, especially if there's another drive on the same IDE cable you'll be using.
 
Turn off computer
Pull the burner out of computer A
Place into computer B

If the drive is connected to the end of the cable the jumper setting will be MAster (MA), but if the drive is connected to the connector in the middle of the cable it will be Slave (SL). You may also place it in the position for Cable Select (CS) which will automatically assign it's role.

Once your done with the drive in computer B,
Power down
replace drive (and Jumper if need be)
 
do i need to take any precautions, my hdd is wrapped up with burner, so i touched sides of hdd, and burner pop in, work around, do i need a monitor and internet? will i need new burners drivers
 
You must log in or register to reply here.
Back
Top