[Case Mod] Lian-Li PC-7B

Ramodkk

Ramodkk

VIP Member
WARNING: Lots of pictures, a ton of them.

Hey guys, here's another case mod. This time, victim is a Lian-Li PC-7. If you want a case to mod, this is THE case, everything comes out easily, perfect canvas for modding.

Anyways, to the mod:

Here are the panels/bezel dissasembled
Picture003x.jpg


The switch planned to go on the side of the front bezel
Picture004x.jpg


Sketching the side window
Picture006x.jpg


The cutting table
Picture007x.jpg


Finished cutting window
Picture009x.jpg


Holes for front handles drilled
Picture011x.jpg


Switch for cathodes and relative location for hole
Picture012x.jpg


Preparing to sand down
Picture013x.jpg


Top window outline
Picture014x.jpg


All parts ready for primer coat
Picture017x.jpg


Primer applied
Picture018x.jpg
Picture019x.jpg


Sprayed with Black Night Metallic
Picture021x.jpg


Black Night Metallic finish
Picture022x.jpg


Front handles
Picture023x.jpg


Accommodation of cathodes on top (alignment was perfect in this case!)
Picture026x.jpg


Perfect spot to run cathode cables through
Picture027x.jpg


Put black honeycomb grill on LED fans
Picture029x.jpg


Put the aluminum grill on the outside of the case
Picture030x.jpg


Case with panels/bezel installed
Picture031x.jpg
 
Last edited:
Finished switch hole and installment
Picture032x.jpg


Right panel paint finish (Black Gloss Enamel)
Picture034x.jpg

Picture035x.jpg


Mod almost done, PC turned on (cathodes off)
Picture037x.jpg

Cathodes on
Picture038x.jpg


That was it for this weekend. Still working on the left side panel (window panel), I had a pretty bad fail on the paint job on it :P Need to sand down again.

Stay tuned
 
wow thats looks real nice so far look farward to the rest of the pics :) :good:
 
You must log in or register to reply here.
Back
Top