Changing A Case

D

DjUnity

New Member
I have a Dell Dimension that i am swapping into a new case.

The problem...

The Dell uses a ribbon cable that goes from the power switch to the front usb board. Then from the USB board to the main board. The case i am using just has a simple 2 pin connector located on the end of a 2 wire cable.

I don't have any idea of which pins (where the existing ribbon cable plugs in) on the main board are for the power button. Has anyone dealt with this? Is there a place to find the pin layout.
 
If I were you, leave it as it is and save money for a new system. I would not take a chance on modding case connections in trying to make it work.
 
johnb35 said:
If I were you, leave it as it is and save money for a new system. I would not take a chance on modding case connections in trying to make it work.
Click to expand...

its for use with a specific program that can only run on 32 bit. It is not worthy of a new system.
 
You must log in or register to reply here.
Back
Top