comp run then stop

H

hlp

New Member
just finish building a comp it start up but after a while it turn off and is not showing anything on the screen
 
What parts are you working with?

Did you use the stock cpu cooler or an aftermarket?

Try running only one stick of RAM in the first slot and
see if that helps.
 
wat part i working with? all, all the parts already been in place
stock cpu
try with one ram still samething
problem is that after it start up for like 30sec or so it just die off
 
cpu-Intel Core 2 Quad Q8200 2.33Ghz 4MB 1333FSB CPU
ram-Corsair 4096MB PC6400 DDR2 800MHz
mb-Asus P5N-D nForce 750i SLI Socket 775 Motherboard
psu-Aspire 500w Silver Alum See Through Power Supply
 
before i bought my aftermarket heatsink for my cpu i had the stock one that came with it and i didnt push the 4 pin things down until they clicked, and i had the same problem. it turned off for about 30 seconds then would just turn off. make sure they all clicked because you have to push them down pretty hard.
 
they do fit but i think 2 of them keep coming loose when i push too hard on the other ones it seem like the mb going to break, does it really matter if is not plug in tight eough but at long as the fan spin should it be alright?
 
You must log in or register to reply here.
Back
Top