Coolermaster Hyperx

Yea its a good cooler. I,ve installed a few of them, not on the 775 but on AM2 and AM2+. I,m running the smaller Hyper TX now.
 
Hi Stranglehold,

thanks for replying,Im just concearned about the plastic vent thing on the back because i dont think there will be enough room between that and my rear exhaust fan :(

im not sure if that duct comes off?
 
I see what you mean with the TX model, your socket sits alittle closer to the edge. I dont (think) you would have a problem. And no you cant take the vent off, well you can but the whole thing is one piece, fan and all attached. I had mine broke down yesterday, if I had known I would have measured the distance from the center of the socket to the edge of the back vent. If you look at where my socket is, there is about 2 inches from the vent to my back fan. You would not have a problem with the 212 model.
 
Last edited:
yeah well with my AC7 pro theres about a 1.5 Inch gap from the exhaust fan so i think thats going to be a problem...damn theres always a stupid problem when it comes to pcs for me.

why cant they make the damn things simple lol :D

if that plastic vent was detachable then there wouldnt be any problems as i could just remove it. :(
 
If you just really wanted the TX model, its plastic so I guess you could snip off the edge if it touched:D. On the TX this gives a good idea of how far it sticks out and how it comes off in one piece.

contents-3.jpg


contents-10.jpg


contents-11.jpg
 
Last edited:
haha get the hacksaw and chop the damn thing off :D

im not sure yet,im going to look around on google later to see if i can get the full dimensions of the thing and measure it up.
 
nah i think its crap.....its loud,it never used to be and the wire keeps falling out the 3 pin power connector so it must go.

i would love a Zalman 9700,but its a bit pricy due to it been all copper lol
 
You must log in or register to reply here.
Back
Top