Critique my build. Ordering TODAY

Actually got that fixed. The problem now is that when I plug in the internet cable, windows doesn't detect it. It says "no connections are available"

Edit: the Ethernet cable is usually shows a green light, but on my new pc it's red-orange. When I go to device manager, there's no network section.

Edit: fixed everything. I'm using my new comp to type this message. :)
 
Last edited:
So today I installed a new heat sink, the Hyper 212+, and I can't seem to start the computer. The monitor doesn't respond, although everything else is moving, the case fans, the psu, the hard drive, the cd, and the graphics card. What's strange is besides the yellow light on the motherboard, the DRAM_LED is flashing red. Any ideas?
 
Look it over and make sure you plugged everything back up again. CPU fan or maybe the 4/8 pin CPU power connector.
 
Hook it up to the onboard and see if it will boot. If so, go into the bios and set the PCIe slot as first that it looks for, can even disable the onboard. Then change it back over to the card. See if it boots.
 
So it doesnt boot on either one. If everything is hooked up right. Unplug it and push the power button a few times. Then reset the bios by the jumper on the board. Plug it back up and see if it will boot
 
Last edited:
You must log in or register to reply here.
Back
Top