front I/O ports?

lethalforce

lethalforce

New Member
on my case i have 4 front ports, 2 usb and 2 audio (mic and headphone) but when i try to plug them into my mobo the names dont mach the ones in the instruction book or on the wire themselves! they matched up for the "power led' and all that but when im trying to plug in the audio ports the wires has a diffrent name han the little prongs on the board...so what should i do?

http://www.newegg.com/product/product.asp?item=N82E16811147026

http://www.newegg.com/product/product.asp?item=N82E16813130056
 
front panel audio connetors:

1-mic in(R)
2-GND
3-MIC POWER (L)(ORNAGE)
4-LINE OUT FR (RED)
5-LINE OUT RR (BLUE)
6-LINE OUT FL (WHITE)
7-LINE OUT RL (YELLOW)

my mobos JAUD1 audio inputs:

1- (2)gnd
2- (1) port 1L
3- port 1R
4- port 2R
5- sene_send
6- port 2L(9)
7- sense2_return(10)
8- key
9- sense1_return
10- presence#


these obviously don't match, any ideas? i'm so frustrated right now
 
Last edited:
For Intel® High Definition Front Panel Audio
Pin Signal Name Description
1 PORT 1L Analog Port 1 - left channel (Microphone)
2 GND Ground
3 PORT 1R Analog Port 1 - right channel (Microphone)
4 PRESENCE# Active low signal that signals BIOS that an Intel® HD Audio dongle is connected to the analog header. PRESENCE# = 0 when an Intel® HD Audio dongle is connected
5 PORT 2R Analog Port 2 - right channel (Headphone)
6 SENSE1_RETURN Jack detection return for front panel (JACK1)
7 SENSE_SEND Jack detection sense line from the Intel® HD Audio CODEC jack detection resistor network
8 KEY Connector key
9 PORT 2L Analog Port 2 - left channel (Headphone)
10 SENSE2_RETURN Jack detection return for front panel (JACK2)

so try
1-mic in(R) goto 1
2-GND goto 2
3-MIC POWER (L)(ORNAGE) goto 3
4-LINE OUT FR (RED) goto 5
5-LINE OUT RR (BLUE) emtpy
6-LINE OUT FL (WHITE) goto 9
7-LINE OUT RL (YELLOW) empty

only the front left and right speaker will work
 
okay here's the problem, i was reading off the instruction manual for my case which is giving me the wrong wires names!

here's the names of the wires straight off the wire not the book

mic in (R) GND <-- 1 wire

line out FL <-- 1 wire
line out RL <---/

line out FR <-- 1 wire
LINE out RR <-- /

mic power (L) <- 1 wire

so when trying to do your suggestion i cant, because some of them are 2 pronged wires that you are telling me must go into a 1 pronged connection

thanks for you help so far by the way :) !!
 
p1000121zd1.jpg



p1000116ss9.jpg
 
You must log in or register to reply here.
Back
Top