Help- Computer will not boot up!

Viperlover

Viperlover

New Member
So I got this new case- A Aerocool Aeroengine 2, but.... I can't quite figure out how to hook up the power switch. And that isn't the only problem, because I hooked up the old power switch and tried it and got nothing. I have a Dell Dimension 3000 micro ATX mobo and I have no clue what the problem is. I made sure all of the wires were tight and in the right places. What do you guys think the problem is?
 
you have put a powersupply in the case right, unless it came with one. Also, if you need to but a power supply make sure that it is enough watts for you system. I would also check to see if you have a 20 or 24-pin conection for you motherboard.
 
ok you guys, screw everything I said earlier, I got it up and running now except it cuts off because I don't have the old fan hooked that was on the back hooked up to it anymore and it will say cpu fan speed error or some crap like that, so how will I go about fixing that? I thought of hooking up one of the 120s that came with it into the spot where the old one went on the motherboard, but the connectors are different. What do I do?
 
It also says- Previous shutdown due to thermal event strike the F1 key to continue, F2 to run the setup utility. And I even hooked up the old fan to it but it gave me the same thing. If you hit F1 it just shuts down.
 
You must log in or register to reply here.
Back
Top