How far can I make er go?

K

Kuli24

Member
I have a:

DFI LANParty UT NF4 ULTRA-D Motherboard ATX S939 NFORCE4 Ultra DDR 2PCI-E16 SATA RAID Sound LAN 1394

AMD Athlon 64 3000+ Processor S939 Venice 1.8GHZ 512K L2 Cache 90NM

Kingston ValueRAM PC3200 2GB 2x1GB DDR400 CL3-3-3 184PIN DIMM Dual Channel Memory Kit


I think this is every bit of info needed to overclock. Anyway, how high could I take this? Have you heard any numbers such as 2.4GHZ?

Thanks
 
i think 2.4 would be achievable on this system, its not unheard of to reach such speeds.
however if you cant reach this speed it will most likely be down to the individual hardware.
 
2.4 should be doable, you'll have to juggle your settings a bit. Set you memory to 166 Mhz, your hyper transport to 4X, and slowly work your front side bus up to about 267 Mhz, you might even hit a little higher if your memory is of good quality.

Good Luck
 
Bah when in doubt jack the voltages! :P (nah im just kidding) But loosen the timings and everything up, ramp the clock then tighten them again :)
 
You must log in or register to reply here.
Back
Top