how to open up ports...

H

haha

New Member
alright so i have two computers hooked up to the D-Link DI-704UP router...and i need to open out the ports 6112-6119...ive trying looking at the site http://portforward.com/, and followed the instructions...but it didnt seem to work...any suggestions? thanks
 
Type in your routers ip address in your IE address bar. Then look for something called 'virtual servers'. I'm not 100% sure it'll be called that because i have a belkin router.

Note: Make sure you do the TCP as well as the UDP.;)
 
nffc10 said:
Type in your routers ip address in your IE address bar. Then look for something called 'virtual servers'. I'm not 100% sure it'll be called that because i have a belkin router.

Note: Make sure you do the TCP as well as the UDP.;)
Click to expand...

is that the only step because ive done that...heh

except instead of doing one udp and one tcp for each port...i went and did "both" for each port cuz i thought that would save time n space...was that a dumb move?
 
haha said:
is that the only step because ive done that...heh

except instead of doing one udp and one tcp for each port...i went and did "both" for each port cuz i thought that would save time n space...was that a dumb move?
Click to expand...

I don't understand what you are saying? You said you didn't do the UDP and TCP, but then you said you did them both!
 
like theres an option as...udp, tcp and both

so i chose both instead of doing each port twice..does that clear it up lol sry
 
alright thanks...but is this the only step that i need to take to open those ports up? thanks so much
 
nffc10 said:
Yes, thanx. Why not try doing the TCP and UDP seperately then.;)
Click to expand...

ok so i just tried it seperately and it didnt work....im so confused lol...i think wht im going to do is im going to press the reset button to reset to manufature defaults and try to do it all over again...
 
You must log in or register to reply here.
Back
Top