HI, I have an HP OfficeJet 7740 Pro. After using expensive original ink cartridges I switched to Orink replacement cartridges. The printer detected that they weren't original. I did some research online and found a file that allowed me to downgrade the firmware to an older version, 1849A. That worked! About 10 months later, I got an error regarding the cyan cartridge; it shows as empty, even though the others are at about 20% (so I assume the cyan one should be, too). I bought four new third-party cartridges—Orink again—but received the error: "There is a problem with the supply system. Try replacing the affected cartridge with a different, non-empty cartridge. If the message reappears, record the message and contact HP." I tried inserting the old, depleted original cartridges; the printer correctly identified them as "depleted" and prompted me to replace them with new original ones. I replaced the four Orink cartridges with another set of new Orink cartridges, but the problem persisted. I then bought a different brand of third-party cartridges—the seller claimed the chips were updated for newer firmware—so I gave those a try. As soon as I inserted them, the printer showed full levels for all four colors, and I thought the issue was resolved. However, after the printer finished its initialization process, the "supply system problem" error appeared again. I removed the printhead; it looks fine, as do the connectors—no signs of corrosion or wear—and I don't see any paper stuck inside. I tried downgrading the firmware again, but that didn't help. The only difference I notice during the downgrade process is the printer status: while all the manuals indicate a "Ready" status, mine shows "Busy." And there are no leftover files in the print queue.This has driven me crazy; I hate to just throw it away without putting up a bit more of a fight. Does anyone know—or have any suggestions on—what I can do to get it working?Thanks