I have a problem

[stephen6n2]

The bit were you plug in earphones in the front of your hardrive, well i have a bit of the earphone pin stuck in it and cant get it out, does anyone know what i can do to get it out because i dont know alot about computers

Thanks

 

[quagmondo23]

Apparently I don't either. How did you plug headphones into your hd. Is that possible, if it is, what can you hear?
Welcome, bye the way.

 

[mep916]

How did you plug headphones into your hd. .

I think he meant the front case connection. Some people refer to their computer as the hard drive. My mom does, anyway...

 

[quagmondo23]

haha, ok.
How is it stuck? Did it snap?

 

[GameMaster]

You can either open your case and pull it out using that special tool...you know, the one you open the case with ! Aha screwdriver yes!
Or you can easily get it to someone whose job that is xd

 

[quagmondo23]

Or you can easily get it to someone whose job that is xd

NO...
Don't give money to someone else to do something anyone can do (Bill Gates for example).

 

[stephen6n2]

haha, ok.
How is it stuck? Did it snap?

Yeah it snapped off

 

[GameMaster]

Who said he should pay it and also who said Bill knows it and also some1 who knows how to open a computer case, well heya , I am sure there are more people who can do it, it's as simple as it's to open a Sony Playstation 3's JoyStick hey, it takes 3 minutes, but just be careful.

 

[quagmondo23]

Emm.
My advice would be to get something like a tweezers or needle and try and prod it out. If that doesn't work maybe get a hammer. Thats the main tool in any computer builders toolbox. If something doesn't fit, hammer it.

 

[quagmondo23]

Who said he should pay it and also who said Bill knows it and also some1 who knows how to open a computer case, well heya , I am sure there are more people who can do it, it's as simple as it's to open a Sony Playstation 3's JoyStick hey, it takes 3 minutes, but just be careful.

If it's their job, more than likely, they'll get paid.

 

[stephen6n2]

Emm.
My advice would be to get something like a tweezers or needle and try and prod it out. If that doesn't work maybe get a hammer. Thats the main tool in any computer builders toolbox. If something doesn't fit, hammer it.

Its actually just the very end of the pin that broke of so it is at the very back of the port and cant get at it with tweezers or a needle, is there anyway the bit were the port is can be takin out so i can get the pin out any other way

 

[quagmondo23]

I'm not sure. Maybe someone else knows more about this subject than I do.