I have a slight problem with the connectors on my Gigabyte

F

Ferozban

New Member
hi,
i bought the GA-770TA-UD3 and a case from ximantek
now i'm quite a noob at patching my pc together.
i have aproblem with 2 front connectors.

both are one pins. one is named "+p led" and the other one is named "-p led"

and the front panel on the motherboard has this labels:

----------------------------
|+MSG-|+PW-|---|+SPEAK-|
|+HD-|-RES+|-CI+|---|+PWR_LED-|
----------------------------

the first row has (2,2,2xemtpy,4) pins
and the second row has (2,2,2,1xemtpy,3) pins

now i got the speaker cable correctly inserted i guess
on the "+HD-" i connected a cable labeld "HD LED"
and on the "-RES+" i connected a cable named "RESET SW"

now it gets tricky and i dont know if i did it right.
i got a cable labeld "POWER SW" which i connected to the first 2 left pins of the 3 pin "+PWR_LED-"

and i still got 2 cables with "+p led" and "-p led"

what do i do? have i done the last part wrong? where shall i put those cables?
please help me :)
~feroz

PS: i got another question about a fan controler i bought. i got the 3 pin connector of the fan controler installed at the "SYS_FAN2" plug instead of the "SYS_FAN1" plug, because its closer and the cables dont get in the way.
does it still work without problems or do i need to put it into the number 1?
 
Last edited:
sounds like the single ones are for the power led. the one you plugged into the led spot should probably be the power switch one. be sure to check for the arrow on the plugs though. arrow indicates positive ;)

if you are nervous about the other ones, go ahead and leave off the p led ones for the time being until you are sure you have the hd led, reset, and power switch ones correct.
 
The leads for the power switch go on pw+-. The 2 single cables are the power led so you need to switch what you have connected.
 
thx for the advice. i've now connected the "POWER SW" to the "+PW-"

ok and also i have to put the "+p led" and "-p led" on the "+PWR_LED-"
but i'm still consued about that. the "+PWR_LED-" is a 3-pin, and the 2 leads are single pins.
so should i just stick the +p to the right pin and the -p to the left pin and leave the middle one empty?
 
You must log in or register to reply here.
Back
Top