just overclocked q6600 can you check if i did it right

xxxalpinexxx80

xxxalpinexxx80

New Member
hey, i just overclocked my q6600 and i wanted you guys to make sure i have my voltages and everything else correct
 
Last edited:
Everything looks fine to me, although your voltage seems to be a bit high for only 3.26GHz. But then again you do have the B3 stepping.
 
i ran orthos for 30 minuites but then i stoped it cause im gonna go to bed my cpu temp stayed at 35.5 but core 1 and core 2 went to 60-70c while both at 100% load and when i stopped orthos the 2 cores shot from 70c to 40-50c

how come pc wizard is telling me that my cpu temp is 35.5 right now when core 1 is 47c and core 2 is 44 and core 3 and 4 are 40
 
I'm on my iPhone but my radiator was freezing but after 20minuites it got worm, do u think I can increase the FSb with the voltages I have
 
i just overclocked farther but i just randomly put the voltage up with out restarting and seeing if it will boot, buit now it does and on cpu-z it runs at 2.4 or 3.5 maby to save electricity

but what is wierd is that pc wizard dosnt detect my board nor voltage e.c.t
 
Last edited:
ya got 3.6 stable :) tried going to 4.0 but crashed 3.6ghz is more then enough anyways but if I did the right bol I think I could get it to 4.0ghz
 
You must log in or register to reply here.
Back
Top