NutmegPluto
New Member
I bought some of this RAM http://www.amazon.co.uk/Kingston-Hyper-4G-1066Mhz-Module/dp/B0016P5B6G/ref=cm_cr_pr_product_top
Apparently it comes at a standard 800mhz and the latency is 5-5-5-15
Anyways I have an asus p5klm am motherboard and I went into the bios, put the RAM speed to 1000mhz (1066mhz wasn't there so I guessed 1000mhz meant 1066mhz) and I put the voltages to 2.27 (supposed to be 2.2 but that wasn't there). Anyways I noticed some webpages werent loading too fast and some applications were taking the same amount of time to load as when I had my 2gb 800mhz RAM. So I went onto CPU-Z and checked my memory
and it says 'max bandwidth PC2-6400 (400mhz) DRAM frequency 500mhz
FSB
RAM 2:3 (my cpu fsb is 1333mhz) CAS# LATENCY (CL) 5.0 clocks
RAS TO CAS DELAY 5 clocks RAS precharge 5 clocks Cycle time (tRAS) 18 clocks (TRFC) 52 clocks'
And in the SPD page it says the voltage is only 1.8v and the frequencies are : Jedec#1 200 Jedec#2 266 Jedec#3 400 and cas latencies are: Jedec#1 3.0 Jedec#2 4.0 Jedec#3 5.0
Does this mean I have not overclocked properly? If so how do I do it right? And what do I do? If this is not clear enough I will put screenshots up but it doesn't seem to be right to me (although I have not OCd ram before)
Apparently it comes at a standard 800mhz and the latency is 5-5-5-15
Anyways I have an asus p5klm am motherboard and I went into the bios, put the RAM speed to 1000mhz (1066mhz wasn't there so I guessed 1000mhz meant 1066mhz) and I put the voltages to 2.27 (supposed to be 2.2 but that wasn't there). Anyways I noticed some webpages werent loading too fast and some applications were taking the same amount of time to load as when I had my 2gb 800mhz RAM. So I went onto CPU-Z and checked my memory
and it says 'max bandwidth PC2-6400 (400mhz) DRAM frequency 500mhz
FSB
RAM 2:3 (my cpu fsb is 1333mhz) CAS# LATENCY (CL) 5.0 clocksRAS TO CAS DELAY 5 clocks RAS precharge 5 clocks Cycle time (tRAS) 18 clocks (TRFC) 52 clocks'
And in the SPD page it says the voltage is only 1.8v and the frequencies are : Jedec#1 200 Jedec#2 266 Jedec#3 400 and cas latencies are: Jedec#1 3.0 Jedec#2 4.0 Jedec#3 5.0
Does this mean I have not overclocked properly? If so how do I do it right? And what do I do? If this is not clear enough I will put screenshots up but it doesn't seem to be right to me (although I have not OCd ram before)
