New Build not working, help!

J

jbrdbr111x

New Member
I just built another pc for my wife, and I have double and triple checked my connections, and all is correct..

I press the power switch, the power comes on, CPU & system fans run just fine.. I hear the HDD, but no display, not even for BIOS.. no beeps, nothing...

I have no clue what's wrong, any ideas,.. I'm so frustrated... !! :confused:
 
Edit.. I took out the ram and put in one by one in each slot and nothing changed.. it has onboard video.. idk what to do all this stuff is brand new!!
 
Stupid question but is all the parts compatible, like are you using a C2D CPU on a non C2D mobo?
 
A few simple things for you to check....

Is your graphics card in correctly? Try push it in some more...

Check that your VGA cable is in place correct, try push it in some more again, try a new VGA cable if you have another?

Check the monitor has power? Try a different power cable? Try a different monitor?
 
agreed^ i had the same problem and turned out that one of my dvi pins bent so it didn't read on my monitior. seems typical of chimei products as my buddy had the same thing happened to him.
 
Yeah I tested the monitor on the pc I'm on atm, and it works fine.. The video is On-Board.. so idk what I can do with it since it's not a separate card.. I double checked the vga cable and pins appear ok, and it was fully seated..

I have the system speaker hooked up, and I don't hear any beeps, not even when I first turn it on.. This has me worried being the parts are all brand new, and I always wear anti-static wrist guard, and make sure Im fully grounded and in a non-static area when working with it..
 
You must log in or register to reply here.
Back
Top