no signal to screen

Computer_Freak

Computer_Freak

Active Member
Hey Guys

I installed a new PSU, RAM and GPU into my bros i5 system.

He has an i5 750, MSI P55 GD45 Board, GTX 560ti

Now yesterday i did all this, and his PC was working fine. the correct drivers were insalled,

I shut down, cause his internet wasnt working, remover the network card, put it back in, and now his screen stays blank (no beeps, all fans working etc etc)

i pushed the GFX card back in toward the slot, made sure the power connections are secure, tried the other DVI port, etc etc

but it now is blank screen, the little LED on the screen still just turns on and off, as if the computer were shut down.

any help?
 
Last edited:
Loose power connections to the card? Make sure all connections are tight, reseat all ram sticks and such.
 
re seated the ram, no help, reseated the network card (cause after i pulled the card out it stoped working???), all power connections were puled out (mobo, CPU, GFX etc), and put back in...

checked screen connections, checked GFX connections. Only thing i can do now is put my 9800GT in there, if it works, then the GFX card must be faulty...
 
Last edited:
If that don't work, try resetting the cmos by removing power from the power supply, remove cmos battery, press the power button on the case a few times to discharge power and then wait 5 minutes and then reconnect everything and try booting up.
 
I took my network card out again, cause i had to remove it to get easier access to teh battery, and i saw it wasnt seated right.

i must have put it in badly (twice).

thanks alot, really appreciate the fast response!!!
 
You must log in or register to reply here.
Back
Top