Overclocking and failing miserably

[ChrisUlrich]

Check signature for parts.

Had it at 3.4ghz and could not get it to work. Brought CPU Voltage (Not FSB Voltage) to 1.25v and still would not stabilize!

Can't even get ram to run stock settings of DDR3 2000! I set ram voltage of 1.95v and set it at 1989 and it wouldn't even turn on!

Help please!

 

[colt1911]

Sent you pm that should help you.

 

[MosIncredible]

May need more CPU voltage than that. What are all of your settings?

 

[ChrisUlrich]

May need more CPU voltage than that. What are all of your settings?

Well, stable so far with 1.240v @ 3.4ghz.

But I can't get the ram to DDR3 2000. It's at 1333mhz and it's so freakin annoying because I bought DDR3 2000 because this board is supposed to freakin support it. I set the ram voltage to 1.95 and cranked it up and won't happen at all.

 

[oregon]

what's your ram ratio to fsb ratio? RAM usually runs at double (triple for DDR3?) the speed of the FSB, but can be adjusted to have different ratios.

 

[ChrisUlrich]

what's your ram ratio to fsb ratio? RAM usually runs at double (triple for DDR3?) the speed of the FSB, but can be adjusted to have different ratios.

DRAM Frequency: 661.1mhz
FSB DRAM: 9.14
CAS# Latency (CL): 9.0 Clocks
RAS# to CAS# Delay (tRCD): 9 Clocks
RAS# Precharge (tRP): 9 Clocks
Cycle Time (tRAS): 24 Clocks
Bank Cycle Time (tRC): 34 Clocks
Command Rate (CR) 1T

Max Bandwidth: PC3-10700h (667mhz)
Frequency: 593mhz and 667mhz
CAS# Latency: 8.0 and 9.0
RAS# to CAS#: 9 and 10.
RAS# Precharge: 9 and 10.
tRAS: 22 and 25
tRC: 31 and 34
Command Rate: blank and blank
Voltage: 1.5 and 1.5

This taken at idle from CPU-Z