Packard Bell Reformat not loading (tap F11 on start up)

BostonBadBoy

New Member
When I press F11 on start up the recovery management will not load up. I need to completly restore the pc as its running slow, programs not working correctly. Anyone know another way I can reformat it?

thanks
 
It came with some discs, Im not sure where they are though. If anyone knows any other way then I would rather go down that route. If not I will have to find the discs.

whats a ''Recovery Boot Disk Creator''

This is on the Packard Bell site
 
It came with some discs, Im not sure where they are though. If anyone knows any other way then I would rather go down that route. If not I will have to find the discs.

whats a ''Recovery Boot Disk Creator''

This is on the Packard Bell site

You usually create the recovery disks when you first purchase the system in case the hard drive ever goes out on you, you can just buy a new hard drive and use the cd's that you created to reinstall the Operating System, all apps and drivers needed, just like when you first brought it home.
 
The older packard bells come with Smart Restore program, and I usually get to this by pressing F11 when the pc starts up. Is there anyway to do the Smart Restore?
 
The recovery partition must be corrupt or damaged. Can you call Packard Bell to see if they can verify that?
 
Back
Top