Please help!

D

dobbin

New Member
Right im new to building my own computer and ive ran into a problem...the computer wont load up at all, i mean it will boot up but there is no output from the vga or the hdmi so it wont show the bios.

The motherboard i have got is: Asus P7H55-M
along with a Intel 13 3.06ghz
and the ram is Corsair 4GB (2x2GB) DDR3 1600MHz

Please help it would mean alot!
 
What video card are you using? Did you use the brass standoffs between case and motherboard?
 
johnb35 said:
What video card are you using? Did you use the brass standoffs between case and motherboard?
Click to expand...

Has integrated with HDMI, I assume that's what he's using.

Are you getting any beeps of some sort? May require you to connect the included speaker. John has a good point with the standoffs, you never answered that question..
 
Ok, what about the brass standoff's, did you use them?

Brass-Stand-Off.jpg
 
Oh sorry yea i have used them i used 9 of them
And yea im using the integrated hdmi slot, and plus i connected the speaker it makes it bleeping noises then it shuts its self off and starts its self back up and so on.
 
Is your heatsink properly attached? Did you remove the plastic cover on the bottom of it? Do you have another power supply you could test it with?

Make sure your ram is seated properly, remove it and then reinstall it.
 
Yea the heatsink is properly installed and i removed the cap, plus i took at the ram and re-installed
No i dont have another power supply "/
 
You said you used 9 of them? It looks like you only need 8, its possible the last one is shorting the board out.
 
Oh ok ill try that now
Also in the user quide it says...' DO NOT forget to connect the 4-pin/ 8-pin ATX+12v power plug. Otherwise, the system will not boot up'
I put in the 4-pin connector then i turned the computer on and it made severe beeping noises soi shut it off.
 
Those would be beep codes, basically telling you there is something wrong with the system. You installed 1600mhz memory which the board doesn't really support.

Do this....

Remove the motherboard from the case and assemble it on a piece of cardboard and see if it will boot up. It would also help to know what power supply you are using? Would need to know make and model.
 
dobbin said:
Also it says that the board supports up to 2133MGHz
Click to expand...

directly from asus website

4 x DIMM, Max. 16 GB, DDR3 2133(O.C.)*/1333/1066 Non-ECC,Un-buffered Memory

1600 isn't listed but should downclock to 1333. Let us know how setting it up outside the case works.
 
Pretty sure he has to many standoffs under the board. The P7H55-M, I can only see 6. They make a P7H55-M pro that has 8.
 
Yeah, thats what i'm thinking. However, I couldn't even find the P7H55-M to find how many standoffs it takes. I was going by the pro version.

Never mind, found it, and it only has 6 spaces for standoffs.
 

Attachments

  • p7h55-m_2d_700x700.jpg
    p7h55-m_2d_700x700.jpg
    97.6 KB · Views: 26
Last edited:
You must log in or register to reply here.
Back
Top